CAN to TTL Serial Communication Module PC6-01 Pneumatic Push in Bowden Extruders for 3.0mm J-Head fitting If your sensor fails during

If your sensor fails during normal use

The carbon brush design tolerates PWM control well with minimal noise generation

Ready to power your next project

35C discharge rate ensures reliable power delivery under demanding flight conditions

Home Networking: Connect your PC

CAN to TTL Serial Communication Module PC6-01 Pneumatic Push in Bowden Extruders for 3.0mm J-Head fitting If your sensor fails duringCAN to TTL Serial Communication Module CAN to TTL Serial Communication Module 3. 3V 5V This is an CAN to TTL Serial Communication Module. The module uses a black backplane high quality circuit board, Which Comes standard 3. 50mm Screw Terminal connector on the end, on the other end has a 5pin headers. There is a power light on the board to indicate the power supply status. The onboard voltage regulator chip supports 3. 3 5V wide voltage power supply.