Howe Panhard Bar Axle Mount - 8" Length - 3/4" Thread 13-RS1-B Factory S197 Mustang Panhard rods

Factory S197 Mustang Panhard rods are made from weak U-shaped stamped steel with soft rubber bushings that allow excessive deflection under load

Offset position is helpful when angling an engine (with transmission attached) in or out of a vehicle

1966-1971 Dodge Coronet

1969-1974 Chevrolet G20 Van

1985-1986 Pontiac Parisienne

Howe Panhard Bar Axle Mount - 8" Length - 3/4" Thread 13-RS1-B Factory S197 Mustang Panhard rodsFits any 3" O. D. axle tube. Made to use on the front of a quick change or either side of a non quick or Ford 9". 8" from the center of the axle to the center of the heim. Available with 3 4" or 5 8" fine thread for the corresponding rod end bearing. Made just long enough so that the panhard bar clears the quick change cover. Clamps to any 3" axle tube. 13" from the center of the axle to the center of the 3 4" rod end bearing. Howe Racing Enterprises