Graphtec Blade Holder For CB15 Series Blades Size_c_60" to 69" Print on plastic

Print on plastic

The press can draw down or swing open

Printing Pressure 1833N (6bar) Power Supply 110/220V 60/50Hz 50W Air Consumption 234 liters/min (8

Drying time: minimum of 20 minutes at 80 ° C / 175 ° F

Simply suction the stone then place it onto the desired decorating surface for the glue fix

Graphtec Blade Holder For CB15 Series Blades Size_c_60" to 69" Print on plasticCompatible with blades: CB15U, CB15U K30*, CB15U, CB15UA, CB15U K301. 5mm** Blade holder with a red top, and brass tip for CB15 blades. These brass tip blade holders plungers are more rigid and lend to more accurate cutting. NOTE: Remove CB15 SP Blade spring before installing into this Blade holder. DO NOT install any blade spring.